Rohrbaugh Products and Accessories > Gunsmithing or Modifications for your Rohrbaugh

problem with round in chamber

<< < (7/7)

PhilZ:

--- Quote from: tracker on May 08, 2019, 10:00:07 PM ---The screw size is 1/16".
http://www.acbsystems.com/boards/rohrbaugh/basefile/gripscrews.htm

--- End quote ---

The hex socket is 1/16".  Is that how the screw size is described?

tracker:
Not exactly, as you suggest. I should have said that the correct Allen wrench size is 1/16".

giansant:

--- Quote from: MikeInTexas on May 08, 2019, 08:17:18 PM ---
--- Quote ---Thanks - I don't see anything on their website - do I need to call them direct?

--- End quote ---

Yes call them, ask for Alex the Rohrbaugh guy. (there is another Alex, that does not deal with Rohrbaughs.)

They sell the grip screws for $5 a set, plus $15 for shipping.  They had both stainless and blued available last year when I ordered my replacements.

Good news is if you buy more stuff, you only get stuck with one shipping charge.

--- End quote ---

Thanks - talked to them today - ordered one of each set.

giansant:

--- Quote from: tracker on May 08, 2019, 10:00:07 PM ---The screw size is 1/16".
http://www.acbsystems.com/boards/rohrbaugh/basefile/gripscrews.htm

--- End quote ---

Great stuff - thank you.

tracker:
One other good thing to know is that if a screw is too tight to loosen because of loctite, don't fight it; just carefully put the heated tip of a small soldering iron on the screw for a few seconds and the screw should come out easily.

Navigation

[0] Message Index

[*] Previous page