Rohrbaugh Products and Accessories > Gunsmithing or Modifications for your Rohrbaugh

R9 parts (specifically, trigger pin)

<< < (2/3) > >>

Covert23:
I apologize for not responding in a timely manner.  Had to put it on the back burner Do to holidays and health issues.  Unfortunately I have not been able to track one down. Just started thinking about it again. Have a doctors apt next week and I’ve been optimistic about it and it’s got me back in better spirits.  I’m going to keep trying.  I was going to send in another pistol this spring for restoration and was going to see if he could make me one while he serviced my other project.  I’ll keep ya posted!  Thank you for checking in!
Jim

ECR:
Feel better James.

I'll look through my machinist's tool box and other areas to see if I have any of those around. At this point, some six years after the sale to Remington, parts are getting tough to find in excess anymore. I don't expect to find any, but I have found things in the past if I keep looking through the old stuff I still have here at my home. I'll let you know over the weekend sometime. I have a full plate this weekend, but I'll give it a shot for you.

Regards,

Eric R.

Covert23:
Very kind of you sir, thank you. I’ll keep searching as well and keep you posted. Jim

ECR:
James,

I found two used barrel pins. One for you and one for me. Send me your address and I'll mail it to you.

Regards,

Eric R.

ECR:
Ah nuts. . . . . . You need a trigger pin, not the barrel pin!  Ugh...….

I'll go give a look now for those. They would be easier to possibly have around.

I'll get back to you A.S.A.P.

ecr

Navigation

[0] Message Index

[#] Next page

[*] Previous page