Author Topic: threaded barrel for R9S  (Read 3013 times)

Offline Nukes

  • New Member
  • *
  • Posts: 7
  • New Member
threaded barrel for R9S
« on: August 28, 2023, 03:12:20 PM »
Howdy Gents! Newbie here with a recently purchased new-in-box R9S serial# 6XXX.

Has anyone found a source for a threaded barrel?

In view of the need to replace the recoil springs every 200 rounds, perhaps the increased back-pressure from using a suppressor may be a non-starter.  Your thoughts?

Oh… extra magazines!

Offline Nukes

  • New Member
  • *
  • Posts: 7
  • New Member
Re: threaded barrel for R9S
« Reply #1 on: August 28, 2023, 03:15:02 PM »
First attempt at post froze, received "page not working" message. Attempted post again, same outcome, but now two duplicate therads exist. Oh well.

Offline cargaritaville

  • Grand Master
  • *****
  • Posts: 1073
Re: threaded barrel for R9S
« Reply #2 on: August 28, 2023, 03:48:35 PM »
Whenever you post, it appears to do nothing, but it does. Hence all the duplicate posts. Welcome aboard from Sarasota Florida!
Having a gun in your hand is much more effective than having the entire police department on the phone!

Offline MikeInTexas

  • Grand Master
  • *****
  • Posts: 815
  • Hello from Texas
Re: threaded barrel for R9S
« Reply #3 on: August 29, 2023, 10:30:05 AM »
If you are worried about the post, before hitting the button again, go open another tab in your browser.  Then navigate to the site again on that new tab and check unread posts.  If it posted, you will see your new post and you can then close the first tab where you originally created the thread.

I know it's been talked about before on here. 

Started this thread a few years ago regarding them, has some discussion.
http://www.rohrbaughforum.com/index.php?topic=8276.msg89428#msg89428

.

Offline Nukes

  • New Member
  • *
  • Posts: 7
  • New Member
Re: threaded barrel for R9S
« Reply #4 on: September 15, 2023, 11:29:32 PM »
Thank you. I think that since the RS9 requires recoil spring replacement q200rds, the increased stress from suppressor back pressure would be problematic.

I figured that I'd ask anyway.