The Rohrbaugh Forum
Rohrbaugh Products and Accessories => Rohrbaugh Wish List => Topic started by: C0untZer0 on June 09, 2014, 10:12:03 AM
-
If the right side of the frame has a cut out for the trigger bar. I would think they could make that same cut out on the other side of the frame. It would shave a little bit of weight off of the gun and I'm assuming it doesn't weaken it structurally since that cut out exists on the right side.
-
I'm not sure if anyone is listening, but this is a good time to make such suggestions. I am sure there will be some changes to the new R-9 before they start rolling off of Remington's CNC machines late this summer.
-
I thought of making slots to insert a T-nut for the grip screws instead of the grip screws screwing directly into the frame.
Something similar to a T-nut -or any way of holding a nut in place, with a tiny lock washer would work better than having the screws go directly into Aluminum :)