34
« Last post by Wanderer on March 14, 2024, 04:41:27 PM »
Well if you shove a piece of metal into another piece of metal enough times the scratches show up to tell you where the pressure is. It is scratching at the back of the magazine well. There are two scratches at the corners of the mag well approximately at the bottom , and an additional larger wear area right before the cutout at the back of the magazine for the hammer assembly, right in the middle. I tried to get a picture.
I have 4 no go magazines.
1 with the welded back, tight in both guns
3 with what appears to be red or brown coloring in the base plate of the magazine in the etching.
I have 2 tight magazines that bind with about 1 centimeter to full insertion. They will go in, however they are pretty difficult to get out but can be done. (These do not have the coloring in the etching)
and 2 that work easily in and out, 1 with no coloring in the etching, and the other has an extension and does not have the original base plate.