The Rohrbaugh Forum

Rohrbaugh Products and Accessories => Rohrbaugh R380 => Topic started by: steveb99 on June 30, 2014, 09:41:30 PM

Title: Recoil Springs
Post by: steveb99 on June 30, 2014, 09:41:30 PM
I have not been shooting my 380 because I have only 1 spring left.  For any 380 owners interested, I emailed Wolff to see if they might have springs for it and the answer was no. If anyone knows any place that has 380 springs available, please let me know.  I also have two R9 springs I would trade for 380 springs if anyone has extras. 

Steve
Title: Re: Recoil Springs
Post by: DDGator on July 01, 2014, 06:51:36 PM

This could be a problem...  :o

 Luckily the 380 doesn't need springs very often.

Title: Re: Recoil Springs
Post by: C0untZer0 on December 16, 2015, 08:23:53 AM
Does anyone know what the round count for replacing the springs in the R380 was?

Also - I'm guessing that springs for the new Remington RM380 will work in the Rohrbaugh R380...
Title: Re: Recoil Springs
Post by: ECR on December 16, 2015, 05:04:11 PM
I wouldn't count on the RM380 springs working in the Rohrbaugh 380. I believe they have a different recoil setup than ours. . . . . . But, not having one of the RM380s in my hands, I could be wrong. Frankly, if you have a Rohrbaugh 380 outer recoil spring. . . . . just stretch it out a little bit and put it back in. . . . . You should be fine. (Inside info) These guns are not brain surgery. . . . . (respectfully speaking here everyone) . . . . . Unless you have shot 3,000 rounds through your R380, I don't think there is much issue with the shot count and replacing the outer recoil spring on them. They are much more forgiving the R9.

Eric R.
Title: Re: Recoil Springs
Post by: MRC on December 16, 2015, 05:35:18 PM
Here is a comparison of the RM380 and the R380 slides, barrels and recoil assemblies.(http://)
Title: Re: Recoil Springs
Post by: C0untZer0 on December 17, 2015, 02:08:23 AM
Thanks for the picture.

Do you mind if I post that on THR?

Its OK if you don't want me to, the picture is yours.  I just end up talking about the RM380 quite a bit on other forums, the amount of ignorance that is out there is astounding...
Title: Re: Recoil Springs
Post by: MRC on December 17, 2015, 07:02:12 AM
No problem on this end, do with it what you want.
Title: Re: Recoil Springs
Post by: C0untZer0 on December 17, 2015, 09:12:10 AM
Thanks :)