The Rohrbaugh Forum
Rohrbaugh Products and Accessories => Cleaning and Maintenance of the R-9 => Topic started by: BytorJr on November 09, 2008, 07:13:29 PM
-
Ok, I realize this is stupid; but I want to be sure that there is no way to put the mag spring in backwards. It looked like it could be done, so I just wanted to verify that I did it properly before I have another spring take off into the upper atmosphere :).
-
That is definitely not a stupid question and from my experience one
can install it backwards. I always lay out the old spring next to the
mag in the proper position prior to installing the new one.
-
Easier said than done since it about took my head off on the way out :). I have no reference point.
-
I had the same problem so I got a reference point by the disassembly
of another magazine. Reassembly issues can be disconcerting also
but skill improves with practice just like the frame and slide. Eye
protection is a good idea when dealing with any spring under pressure.
There must be a more objective way of describing the proper spring
alignment but I don't know it.
-
BytorJr:
With apologies for my having overlooked this thread until now, here is a link to Chris's photograph and comments on R9 magazine parts and assembly in the FAQ Sheet:
http://www.acbsystems.com/boards/rohrbaugh/basefile/mag-parts.htm
And, as Tracker notes, your question is not "stupid." Far from it. As a matter of fact, in my opinion, the only "stupid" questions are those not asked when answers are not known.
-
Thanks!!! I've been there before, but totally forgot about his maintenance section. Time to put my safety glasses on :).
-
Ben, good luck and keep your head down ;) :D Tom