Author Topic: Takedown tool  (Read 2568 times)

Offline BytorJr

  • Expert
  • ***
  • Posts: 181
Takedown tool
« on: November 03, 2008, 01:31:37 AM »
Is the takedown tool supposed to fit rather tightly around the shaft of the guide rod?  Mine was kind of hard to get on and off; but worked like a champ nonetheless.  I don't have as good of luck with it on the positioning of the pin, but man, it man one heck of a difference battling the spring.  

Also, do ya'lls springs get stuck forward the first time during reassembly?


Offline CaptBW

  • Master
  • ****
  • Posts: 376
Re: Takedown tool
« Reply #1 on: November 03, 2008, 10:52:14 PM »
My takedown tool fits loosely on the shaft. Maybe you need to open it up with a small file.
ACTA NON VERBA