Rohrbaugh Products and Accessories > Gunsmithing or Modifications for your Rohrbaugh
problem with round in chamber
PhilZ:
--- Quote from: tracker on May 08, 2019, 10:00:07 PM ---The screw size is 1/16".
http://www.acbsystems.com/boards/rohrbaugh/basefile/gripscrews.htm
--- End quote ---
The hex socket is 1/16". Is that how the screw size is described?
tracker:
Not exactly, as you suggest. I should have said that the correct Allen wrench size is 1/16".
giansant:
--- Quote from: MikeInTexas on May 08, 2019, 08:17:18 PM ---
--- Quote ---Thanks - I don't see anything on their website - do I need to call them direct?
--- End quote ---
Yes call them, ask for Alex the Rohrbaugh guy. (there is another Alex, that does not deal with Rohrbaughs.)
They sell the grip screws for $5 a set, plus $15 for shipping. They had both stainless and blued available last year when I ordered my replacements.
Good news is if you buy more stuff, you only get stuck with one shipping charge.
--- End quote ---
Thanks - talked to them today - ordered one of each set.
giansant:
--- Quote from: tracker on May 08, 2019, 10:00:07 PM ---The screw size is 1/16".
http://www.acbsystems.com/boards/rohrbaugh/basefile/gripscrews.htm
--- End quote ---
Great stuff - thank you.
tracker:
One other good thing to know is that if a screw is too tight to loosen because of loctite, don't fight it; just carefully put the heated tip of a small soldering iron on the screw for a few seconds and the screw should come out easily.
Navigation
[0] Message Index
[*] Previous page
Go to full version