The Rohrbaugh Forum
Rohrbaugh Products and Accessories => Rohrbaugh R380 => Topic started by: steveb99 on June 30, 2014, 09:41:30 PM
-
I have not been shooting my 380 because I have only 1 spring left. For any 380 owners interested, I emailed Wolff to see if they might have springs for it and the answer was no. If anyone knows any place that has 380 springs available, please let me know. I also have two R9 springs I would trade for 380 springs if anyone has extras.
Steve
-
This could be a problem... :o
Luckily the 380 doesn't need springs very often.
-
Does anyone know what the round count for replacing the springs in the R380 was?
Also - I'm guessing that springs for the new Remington RM380 will work in the Rohrbaugh R380...
-
I wouldn't count on the RM380 springs working in the Rohrbaugh 380. I believe they have a different recoil setup than ours. . . . . . But, not having one of the RM380s in my hands, I could be wrong. Frankly, if you have a Rohrbaugh 380 outer recoil spring. . . . . just stretch it out a little bit and put it back in. . . . . You should be fine. (Inside info) These guns are not brain surgery. . . . . (respectfully speaking here everyone) . . . . . Unless you have shot 3,000 rounds through your R380, I don't think there is much issue with the shot count and replacing the outer recoil spring on them. They are much more forgiving the R9.
Eric R.
-
Here is a comparison of the RM380 and the R380 slides, barrels and recoil assemblies.(http://)
-
Thanks for the picture.
Do you mind if I post that on THR?
Its OK if you don't want me to, the picture is yours. I just end up talking about the RM380 quite a bit on other forums, the amount of ignorance that is out there is astounding...
-
No problem on this end, do with it what you want.
-
Thanks :)