Rohrbaugh Products and Accessories > Rohrbaugh Wish List

Not really a wish but just a thought

(1/1)

C0untZer0:
If the right side of the frame has a cut out for the trigger bar. I would think they could make that same cut out on the other side of the frame.  It would shave a little bit of weight off of the gun and I'm assuming it doesn't weaken it structurally since that cut out exists on the right side.

DDGator:
I'm not sure if anyone is listening, but this is a good time to make such suggestions.  I am sure there will be some changes to the new R-9 before they start rolling off of Remington's CNC machines late this summer.

C0untZer0:
I thought of making slots to insert a T-nut for the grip screws instead of the grip screws screwing directly into the frame.

Something similar to a T-nut -or any way of holding a nut in place, with a tiny lock washer would work better than having the screws go directly into Aluminum :)

Navigation

[0] Message Index