Author Topic: Not really a wish but just a thought  (Read 6965 times)

Offline C0untZer0

  • Grand Master
  • *****
  • Posts: 611
Not really a wish but just a thought
« on: June 09, 2014, 10:12:03 AM »
If the right side of the frame has a cut out for the trigger bar. I would think they could make that same cut out on the other side of the frame.  It would shave a little bit of weight off of the gun and I'm assuming it doesn't weaken it structurally since that cut out exists on the right side.
« Last Edit: June 09, 2014, 10:14:39 AM by C0untZer0 »

Offline DDGator

  • Forum Administrator
  • Administrator
  • Grand Master
  • *****
  • Posts: 2630
    • The Rohrbaugh Forum
Re: Not really a wish but just a thought
« Reply #1 on: June 09, 2014, 10:33:14 AM »
I'm not sure if anyone is listening, but this is a good time to make such suggestions.  I am sure there will be some changes to the new R-9 before they start rolling off of Remington's CNC machines late this summer.

Duane (DDGator)
Rohrbaugh Forum Administrator
E-mail: Admin-at-RohrbaughForum.com

Offline C0untZer0

  • Grand Master
  • *****
  • Posts: 611
Re: Not really a wish but just a thought
« Reply #2 on: June 09, 2014, 10:44:53 AM »
I thought of making slots to insert a T-nut for the grip screws instead of the grip screws screwing directly into the frame.

Something similar to a T-nut -or any way of holding a nut in place, with a tiny lock washer would work better than having the screws go directly into Aluminum :)
« Last Edit: June 09, 2014, 10:47:02 AM by C0untZer0 »