Rohrbaugh Products and Accessories > Gunsmithing or Modifications for your Rohrbaugh

Gunsmith Recommendations

<< < (4/9) > >>

ECR:
Hello J,

You need to phone me. I have some questions for you.

631 - 875 - 5318

Speak with you soon. Let's see what we can do here.

Regards,

Eric Rohrbaugh

offrdmania:

--- Quote from: JMH on September 05, 2017, 12:58:37 PM ---Grease to the barrel and slide around ejection area definitely helped. Thank you offrdmania. But problem remains. I made a video that might help. If you want to see it, copy and paste this link in your browser: https://youtu.be/BnkcaDy62cw

Also, took photos and one of them might shed light on problem. Photos show the grease and hopefully this will not obscure view. Also, I compressed the photos to be small enough to meet the specification of this forum. I have them in much higher resolutions.

I have no explanation for what is happening. Everything seems in order to me. Your ideas much appreciated.

--- End quote ---

I have an idea. If you reassemble the slide and install it back onto the frame but don't install the pin... Does it still bind 5mm back?

JMH:
Hello Eric, Would much appreciate your input. I will call between 12 & 1 Eastern. Hello offrdmania, good question. I was able to replicate the symptom with a replacement roll pin from Williams Gun and then without any roll pin. At the point where the slide hits something (approx. 5mm from 'at rest' position) the edge of the hole in the frame for the roll pin is just barely visible. On another topic, I noticed the four photographs I uploaded are not with my previous post. I made certain that all four combined were well under the size limit. Learning curve probably. But that is for another day.

ECR:
Good discussion today J. Hopefully you can make her well again.

Please let me know how you make out.

Eric R.

tracker:
Please keep us all posted.

Navigation

[0] Message Index

[#] Next page

[*] Previous page