Rohrbaugh Products and Accessories > Gunsmithing or Modifications for your Rohrbaugh
grip screw removal
rooster:
I have a problem with one of my grip screws. The left side bottom screw is in so tight that I have broken 1 allen wrench trying to remove it. And now the allen head is rounded out and the wrenches no longer fit. My question is, since it is the left panel do I ever have to remove it for maintenance? I was thinking of drilling through the screw and retapping. I also thought about removing the front screw and then rotating the panel down and maybe the screw will lossen up, but then if the head breaks I am "screwed". Also has anyone detailed striped there pistol yet? If so how?
RJ HEDLEY:
I also thought about removing the front screw and then rotating the panel down // rooster
This will not work, there are index pins under there , in addition to the screws.
Only thing I can think of is to use a small cut off wheel in a Dremel, and cut a slot in the screw head..
BillinPittsburgh:
I've heard that you can drill into a screw and cause it to shatter (obviously safety glasses are a must), but have never tried it personally. Of course you'll need a new screw to put the grip panel back on, but you'll probably need that no matter how you get the screw out.
R9SCarry:
Aesthetics aside with a buggered screw - IMO that left panel need never come off!! On my FAQ site are some pics of a full take down if that helps tho not much use re the screw dilemma.
The most critical thing if drilling out a screw is - precision - start on center and stay on center. This will mean use of a small drill sufficient to not ruin the female thread - and speed and feed will have to be very finely controlled - and with cutting fluid/oil too. The screws are IIRC stainless and hard therefore.
NO hand drill - this is, if attempted, a drill press job. If t'were me - I'd live with it.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~Meant to add - Allen wrenches MUST be true 1/16" (0.0625") - ''cheapie'' ones that are sloppy will give problems because usually under size and so damage the head.
rooster:
Thanks r9s, I just went to your site and after looking at your pictures I agree that there is probably no reason to take the left grip panel off. so for now I am going to leave well enough alone.
Navigation
[0] Message Index
[#] Next page
Go to full version