The Rohrbaugh Forum
Rohrbaugh Products and Accessories => Cleaning and Maintenance of the R-9 => Topic started by: turkeyhunter on March 28, 2017, 07:36:07 PM
-
I have never taken either of my R9 apart so I decided to do so. I followed the factory instructions to remove the slide pan. I had no problem removing the pin, taking it apart and putting it back together on the first gun. On the second, I had no problem removing the pin but the slide will not slide off. What do I do? What is the problem? Thanks for your help.
-
Did you remove the mag on the second gun?
-
Mag removed.
-
Have you ever fired the pistol? Did the slide rack normally? Was the pin intact?
-
Just a shot in the dark but I would reinsert the pin, rack the slide a few times, and start over. I have had problems in reassembly when I didn't have the pin in all the way and the slide would not move. Maybe Eric has some thoughts.
-
backupr9: I have not fired it. I believe it to be unfired except for factory rounds. I don't think it has ever been apart but I can't say any of this with absolute certainty. The slide does rack normally. The pin is intact. Does not look damaged. I don't think it has ever been out before.
Tracker: I will do that tonight, ie rack slide a few times and try again.
Thank you both for your help.
-
You Tube has some great videos on field stripping one.
-
Also, you may have a tight slide to frame fit--see my above post to Kevin regarding the use of 1200 grit silicone carbide valve lapping compound to improve the tight fit, if that is the case.
-
Tracker: your the man. It worked. Seems crazy but that's why I'm not an engineer. Thx for your help
-
You are very welcome. I am not an engineer, either, but having been a pilot for 37 years sometimes it is just a matter of resetting a circuit breaker--so glad it worked for you.