The Rohrbaugh Forum

Rohrbaugh Products and Accessories => Rohrbaugh Accessories => Topic started by: RJ HEDLEY on June 08, 2005, 04:35:51 PM

Title: Take down tool
Post by: RJ HEDLEY on June 08, 2005, 04:35:51 PM

I send this sketch to Eric this AM,  for his concideration.  He said he would think about it  ;D  
 (http://img.photobucket.com/albums/v497/rhedley/Rohrbaughtakdowntool007.jpg)

Title: Re: Take down tool
Post by: Michigunner on June 08, 2005, 04:46:00 PM

Excellent, RJ.

We absolutely need a Rohrbaugh approved takedown tool.

I'm glad to see it come into discussion again.

Title: Re: Take down tool
Post by: Brenden on June 11, 2005, 05:59:32 PM

Very practical design RJ.. 8)

I will buy when available.. ;D

Title: Re: Take down tool
Post by: Richard S on June 11, 2005, 06:45:39 PM

RJ:

Got your PM.  Thank you, Sir.

I'll take two copies of your new tool once it goes into production, just in case one of them goes missing.  My little wife will also welcome it, since she is still patiently providing the third hand which I seem to require to field strip and reassemble my R9s.

Title: Re: Take down tool
Post by: Aglifter on June 11, 2005, 07:08:56 PM

If someone can figure out the dimensions, that seems like it would be a fairly simple thing to have made at a shop -- unless I'm missing a sublety, it seems that all would be required is a piece of stock cut to the proper dimesions, and a torx head welded on... admittedly, w/o the Rohrbaugh name, and probably not as attractive.