The Rohrbaugh Forum
Rohrbaugh Products and Accessories => Rohrbaugh Accessories => Topic started by: RJ HEDLEY on February 02, 2007, 04:13:40 PM
-
Thought this may interest some of you guys..
(http://img.photobucket.com/albums/v497/rhedley/2N1Tools001.jpg)
-
RJ,
I hope you know because I am drawing somewhat a blank on this at the moment.. :o
The one larger piece, that is different than the rest, is throwing me off!!
Spacers of some type,to hold open a piece of "equipment" ???
Hard to determine what these are "size" wise.. ;)
Brenden
OK-Looking at it just a bit more-I see that the larger piece is just waiting to become 2 small pieces,once cut!! ;)
Duh...
-
That is material for more RJ teardown tools. ;D
-
Probably right on that.. ;)
I just can't "see" the finished product from the stock shown.. :o
If it is, I will order another,as I have been holding off to make sure that other folk's got one!! ;)
Brenden
-
The smaller pieces are to be cut diagonally to form two "TOOLS". All surfaces are then finished on belt sander.
I started with 10' of the 1/4" X 5/8" brass stock. Then a machine shop milled in the SLOTS for me.
-
RJ,
Very good of you for doing another run..
The guys will appreciate it more than you know..
I had my 1st takedown out and was comparing with the pics,when the pieces made sense.. 8)
Thanks RJ...
Brenden
-
No second run, photo depicts the last of the original run. :'(