The Rohrbaugh Forum

Rohrbaugh Products and Accessories => Rohrbaugh R9 (all variations) => Topic started by: Newt on April 28, 2005, 08:33:57 PM

Title: Take Down
Post by: Newt on April 28, 2005, 08:33:57 PM

 ;) :D ;D 8)Grab top of slide with left hand and push butt of grip into stomach while pulling slide back until hole lines up. Push pin out with punch in right hand. Done it twice, piece of cake. :)

Title: Re: Take Down
Post by: rooster on May 01, 2005, 10:40:44 AM

This also helps, put muzzle end of slide against the corner of a table ( one that will not scrath finish) right side of pistol facing up.  You also have to clear frame. push forward until holes line up and drift out pin. To assemble do the same thing but have the left side of pistol facing up.

Title: Re: Take Down
Post by: RJ HEDLEY on May 01, 2005, 12:28:21 PM

My "THIRD HAND' method..........note the leather padded jaws

(http://www.fototime.com/B834561EF8B464D/standard.jpg)

(http://www.fototime.com/FC9BD83D817B513/standard.jpg)

Title: Take Down
Post by: TW on May 01, 2005, 01:08:50 PM

>>Hi RJ...!...

Is that a pic of your super secret Rohrbaugh R9 Vise Holster...?...if so, how much...?...and does it come with a mag pouch at $15 like with your other Holsters...?...**grins**...TW<<

Title: Re: Take Down
Post by: RJ HEDLEY on May 01, 2005, 01:33:21 PM

Vise Holster ??    Well, it does have excellent retention..   ;D

Title: Take Down
Post by: TW on May 01, 2005, 08:00:13 PM

Quote

Vise Holster ??    Well, it does have excellent retention..   ;D

>>Yes, but...  What about the add on Mag Holster...or does that only come with Pocket Models...?...TW<<