The Rohrbaugh Forum

Miscellaneous => Classifieds -- For Buying or Selling => Topic started by: geminidan on June 23, 2009, 08:27:05 AM

Title: Looking to buy Take Down Tool
Post by: geminidan on June 23, 2009, 08:27:05 AM

New R9 , looking for a good take down tool any suggestions????   tx Dan

Title: Re: Looking to buy Take Down Tool
Post by: MrsFosforos on June 23, 2009, 06:58:01 PM

IDMparts.com has RJ 2 in 1 tools listed in stock. One end is a slide stop and the other end holds the spring together for reassembly.
http://www.idmparts.com/index.php?cPath=1_25 (http://www.idmparts.com/index.php?cPath=1_25)

For a punch, I use a glock armorer's tool.

Title: Re: Looking to buy Take Down Tool
Post by: geminidan on June 23, 2009, 09:40:50 PM

Thanks everyone for your help!! Dan :-*

Title: Re: Looking to buy Take Down Tool
Post by: onafile on October 05, 2009, 07:22:45 PM

Dan Any luck finding the ADM takedown tool??? I went to their site and it would not respond when I tried to click on the tool! Tom

Title: Re: Looking to buy Take Down Tool
Post by: MrsFosforos on October 05, 2009, 09:10:51 PM

Quote

Dan Any luck finding the ADM takedown tool??? I went to their site and it would not respond when I tried to click on the tool! Tom

IDM hasn't kept the items in stock (which is disappointing considering they were the only ones making them); but there was a post a while back about (http://www.rohrbaughforum.com/YaBB.cgi?board=Cleaning;action=display;num=1127505416;start=61#61) making a similar takedown tool by drilling a piece out of the end of a toothbrush.  It might make do until someone else picks up the gap IDM has left!