Author Topic: FYI on the Robar NP3 finish  (Read 2980 times)

Offline Z

  • Grand Master
  • *****
  • Posts: 1566
FYI on the Robar NP3 finish
« on: April 25, 2012, 03:36:45 PM »
I spoke to Maria today to order a set of the blue carbon fiber VZ grips. I told her i was going to send in one of my PUPs for the Robar NP3 finish and below is the response she had sent me. She said some people who sent in their R9 for the NP3 finish had some problems so here is the list of what can be coated and what cannot be coated.

Can Be Coated: Slide, Frame, Trigger, Barrel, Plunger, Barrel Pin, Trigger / Mag Pins, Magazine Release and Magazines

DO NOT Coat: Extractor, Ejector, Sear / Trigger Bar, Hammer, Springs and Grip Screws

If there is a part not on the list donít assume that itís ok to coat give us a call first to verifyÖ
« Last Edit: May 18, 2012, 09:57:46 AM by Z »

Offline Giraffes

  • Expert
  • ***
  • Posts: 123
Re: FYI on the Robar NP3 finish
« Reply #1 on: April 26, 2012, 02:37:40 PM »
Thanks for the info! I wonder if the same goes for hard chrome finishes. Getting ready to send mine in soon.

Offline Z

  • Grand Master
  • *****
  • Posts: 1566
Re: FYI on the Robar NP3 finish
« Reply #2 on: April 26, 2012, 02:45:46 PM »
I am not sure.
You may want to contact Maria.
Bob Cogan of AP&W may know as well.

Offline Giraffes

  • Expert
  • ***
  • Posts: 123
Re: FYI on the Robar NP3 finish
« Reply #3 on: April 26, 2012, 03:07:42 PM »
Good advice, I'll check with Maria before I send it to AP&W.