Author Topic: What is this? (Read 7368 times)

RJ HEDLEY · « **on:** February 02, 2007, 04:13:40 PM »

Thought this may interest some of you guys..

Brenden · « **Reply #1 on:** February 02, 2007, 09:03:37 PM »

RJ,
I hope you know because I am drawing somewhat a blank on this at the moment..

The one larger piece, that is different than the rest, is throwing me off!!

Spacers of some type,to hold open a piece of "equipment"

Hard to determine what these are "size" wise..

Brenden

OK-Looking at it just a bit more-I see that the larger piece is just waiting to become 2 small pieces,once cut!!

Duh...

bigyimmy · « **Reply #2 on:** February 02, 2007, 09:38:24 PM »

That is material for more RJ teardown tools.

Brenden · « **Reply #3 on:** February 03, 2007, 12:15:19 AM »

Probably right on that..

I just can't "see" the finished product from the stock shown..

If it is, I will order another,as I have been holding off to make sure that other folk's got one!!

Brenden

RJ HEDLEY · « **Reply #4 on:** February 03, 2007, 11:50:51 AM »

The smaller pieces are to be cut diagonally to form two "TOOLS". All surfaces are then finished on belt sander.

I started with 10' of the 1/4" X 5/8" brass stock. Then a machine shop milled in the SLOTS for me.

Brenden · « **Reply #5 on:** February 03, 2007, 12:46:03 PM »

RJ,
Very good of you for doing another run..
The guys will appreciate it more than you know..

I had my 1st takedown out and was comparing with the pics,when the pieces made sense..

Thanks RJ...

Brenden

RJ HEDLEY · « **Reply #6 on:** February 03, 2007, 01:32:53 PM »

No second run, photo depicts the last of the original run.

News: